GE Dishwasher · Code C5

GE Dishwasher C5 code: Pump-out time too short

The drain finished much faster than it should, which usually means very little water got into the tub in the first place.

Most common causes

  1. Water supply valve under the sink turned off or only partly open
  2. Float stuck in the up position
  3. Low water pressure or restricted inlet

What you can safely check yourself

  1. Make sure the water supply valve under the sink is fully open.
  2. Tap the float on the tub floor so it moves freely.
  3. Clean debris from around the float and sump.

Unplug the appliance before moving or cleaning anything. Do not open panels, touch gas connections or bypass safety switches.

Checked against: products.geappliances.com. Meanings can vary by model; check your owner’s manual.

Quick answers

What does C5 mean on a GE Dishwasher?

The drain finished much faster than it should, which usually means very little water got into the tub in the first place.

Can I clear the C5 code myself?

Try these first: Make sure the water supply valve under the sink is fully open. Tap the float on the tub floor so it moves freely. Clean debris from around the float and sump. If the water is on and the float moves freely but C5 comes back, call a technician to check the water inlet valve and float switch.

How much does it cost to fix a C5 code?

It depends on the cause. At FixPro the diagnostic visit is $79.00 and is credited in full to the repair; you get a flat-rate quote before any work starts.

Other GE Dishwasher codes

C1 · Slow drainC2 · Drain blockedH2O · Low or no waterC3 · Will not drainC4 · Float switch stuckC6 · Water too coldC7 · Temperature sensor circuit faultC8 · Detergent cup blockedFTD · Failure to drainPF · Power failure

Still showing the code?

A FixPro technician will find the cause and give you a flat price. $79.00 diagnostic, credited toward the repair.

Book a repair →