GE Washer · Code H2O SUPPLY / IE

GE Washer H2O SUPPLY code: No water supply

The washer isn't sensing water coming in. On some models the Wash and Rinse lights blink instead of showing a code. GE front-load washers run the drain pump for about four minutes as a precaution when this happens.

Most common causes

  1. Water faucets behind the washer turned off
  2. Kinked fill hoses
  3. Very low household water pressure
  4. Faulty water level (pressure) sensor

What you can safely check yourself

  1. Make sure both hot and cold faucets behind the washer are fully open.
  2. Straighten any kinks in the fill hoses.
  3. Wait out the few-minute lockout, then restart the cycle.

Unplug the appliance before moving or cleaning anything. Do not open panels, touch gas connections or bypass safety switches.

Checked against: products.geappliances.com · products.geappliances.com. Meanings can vary by model; check your owner’s manual.

Quick answers

What does H2O SUPPLY mean on a GE Washer?

The washer isn't sensing water coming in. On some models the Wash and Rinse lights blink instead of showing a code. GE front-load washers run the drain pump for about four minutes as a precaution when this happens.

Can I clear the H2O SUPPLY code myself?

Try these first: Make sure both hot and cold faucets behind the washer are fully open. Straighten any kinks in the fill hoses. Wait out the few-minute lockout, then restart the cycle. GE recommends service if the water is on and the error continues. The pressure sensor may be at fault.

How much does it cost to fix a H2O SUPPLY code?

It depends on the cause. At FixPro the diagnostic visit is $79.00 and is credited in full to the repair; you get a flat-rate quote before any work starts.

Other GE Washer codes

dE · Lid openFE · Water level too highLid light blinking · Lid not opened between cyclesUE · Unbalanced load

Still showing the code?

A FixPro technician will find the cause and give you a flat price. $79.00 diagnostic, credited toward the repair.

Book a repair →